Specifications:
- Max Swing Over Bed: 27.56"
- Max Cutting Diameter: 15.35"
- Max Cutting Length: 13.78"
- Maximum Distance Between Spindles: 51.18"
- X-Axis Travel Turret Upper: 11.02"
- X-Axis Travel Turret Lower: 7.87"
- Z-Axis Travel Turret Upper: 37.78"
- Z-Axis Travel Turret Lower: 38.78"
- Y-Axis Travel: +/- 2.76"
- B-Axis Travel: 38"
- C-Axis Indexing: 0.001 Degree
Spindle:
- Speed: 4,000 RPM
- Motor: 30 HP
- Nose: A2-8
- Bore: 3.46"
Sub-Spindle:
- Speed: 4,000 RPM
- Motor: 30 HP
- Nose: A2-8
- Bore: 3.46"
- Bar Capacity: 2.87"
Speeds:
- Rapid Traverse Rate (X/Y Axes): 944 IPM
- Rapid Traverse Rate (Y): 472 IPM
Live Tools:
- Rotary Tool Motor: 7.5 HP
- Rotary Tool Spindle Speed: 6,000 RPM
Turrets:
- Tool Capacity Upper Turret: 12 Tools
- Tool Capacity Lower Turret: 12 Tools
General:
- Machine Weight: 31,000 Lbs
- Dimensions: 180" x 110" x 110"
- Bar Feeder Dimensions: 80" x 65"
Tool holders:
- Boring bar 6
- Part off 1
- Turning 7
- Radial milling 3
- Face milling 5 (two of them are brand new- these are $3600 each from Mori)
Comments:
- Comes with an LNS barfeeder but it needs quite a bit of work - I have a list of
- parts that it needs.
- Some of the covers are banged up a bit.
- Has 3 jaw chucks on it and comes with a few sets of jaws.
- All alignments are good
- Parts catcher/work conveyor work fine
- Has chip conveyor that works.
- Both main and sub side tool presetters work
- 8 spindle liners too
- Missing one coolant pump
- Plus one or two pallets/crates of tooling and accessories- could probably put it
- all in the machine or coolant tank
- To the best of our knowledge all details listed below are deemed correct
- It is the buyers responsibility to confirm ALL details prior to purchase
|