Capacity:
- Chuck Size: 75"
- Swing Over Bed Ways: 127"
- Swing Over Cross Slide: 87,9"
- Distance Between Centers: 360"
Spindle:
- Speeds: 62 RPM
- Main Motor: 75 HP
Dimensions:
- Floor Space (L x W): 697" x 132"
- Weight (approx.): 180,152 pounds
- Overall Lenth of Bed: 540"
- Width of Bedways: 90"
- Maximum Work Piece Weight, 1-Steady Rest: 160,135 pounds
Equipped With:
- Fanuc 0iTC Control (Retrofitted in 2010)
- 4 way Bed Construction
- 2 Carriages
- 75 HP Main Drive
- New Roller Bearings In Headstock In 2005
- New Lubrication System, New Pump, Relay Wire, Wirings
- Operators Remote Pendant
- 75" 4-Jaw Chuck With 4-Top Jaws
- 2-Carriages, Front & Rear
- Front Carriage with Fanuc Red Cap Servo Motors On Cross Slide
- Rear Carriage with Master Setco Servo Slide & Tool Post
- 4-Way Bed Construction
- Heidenhain Scales
- Powered Tailstock, Sits on Center Bedways
- (2) 10" - 24" Roller Steady Rests (New 1999)
- (2) Work Rests
- 20.5" Head & Tailstock Risers (Added In 1986)
- (1) Indexable Tooling Riser
- (1) Solid Tooling Riser
- Threading
Comments:
- Rebuilt in 2015 when installed
- Drive nut on the rear center replaced
- Side rail for the main carriage replaced Drive motors on the rear center replaced
- Programming on the controller reinstalled and configured
- Power upgraded to 575 volt
- The current owner has their own engineers and they did the rebuild
- Do the X axis and Z axis have a ball screw? Yes
- What is the original year of Manufacture? Unknown but think it is in the 60s. It
- was rebuilt in the early 2000s
- Is the spindle smooth running or producing noise? Very Smooth
- The machine can be operated manually through the control.
|