PALLETS:

• Pallet Length x Width: 19.6" x 19.6"
• # of Pallets: Two Pallets
• Max. Pallet Load:
• Pallet Indexing-Deg.: One Degree

CAPACITY:

• X-Cross/Long: 29.5"
• Y-Vertical: 29.5”
• Z-Spindle: 29.5"

FEED RATES:

• Rapid Rate: 787 ipm
• Cutting Rate:

SPINDLE:

• Speed Min. - Max.: 0-7000 rpm
• Motor HP (Continious): 25 hp
• Taper: CT-50

TOOL CHANGER:

• Positions: 40 ATC

General:

• Electrics: 460 Volts
• Dimensions (W x D x H): 10' x 15' x 10'
• Weight (approximate): approx 30,000 lbs.

Equipped With:

• Acramatic 950 control
• Color graphics
• Full tool library
• Floppy drive
• RS-232 communication
• High speed DNC
• Full set of operating, parts, service, and programming manuals
• with multiple copies of many
• Set of machine schematics and control executive software disks
• High-low gearbox (“XT” package)
• Through spindle coolant
• Pallet wash down coolant
• Dual chip augers into belt type chip conveyor
• Fully enclosed (including pallet setup station)
• Rotating pallet setup station
• Double arm ATC with side door access for loading tools
• Internal transformer for almost any incoming voltage
• Renishaw receiver

Spare parts:

• 2 extra pallets (4 in all)
• New ball screw and bearings
• New servo couplings
• New servo motor
• New tool changer motors
• New coolant rotary unions
• New wiring harnesses
• New cable carriers
• New Z & X axis way covers
• Bags of new tool holder retainers for tool chain pockets
• New tool changer arm
• Piles of seals, gaskets, small parts, and misc
• Approx $25,000 worth of spare machine parts

Tool Presetter:

• Sold Seperately
• Parlec-Zoller vertical style. Year mfg:1986
• Assorted tooling - list available upon request

Comments:

• Approximately 18,000 spindle hours
• This machine has been in storage since 2003
• The machine was purchased for a specific job that fell through
• Tooling available
• Excellent Running Condition
• Condition report available upon request
• The machine was sprayed with a rust inhibitor before it was removed from
• service